Systèmes Éconergie Before & After Photos

This attic had an inadequate amount of insulation, and the client preferred to call in a professional to ensure an effective solution.Our team of workers removed the existing insulation to seal all the holes where air was escaping. Additionally, we blew about 17 inches of TruSoft cellulose fiber insulation onto the attic floor to achieve an optimal thermal value of R60.

The problem: When we've inspected this attic. Jerry our home comfort specialist found that this attic has not enough fiberglass and they were quite a bit of condensation on the ceiling roof. The client has noticed this, too, and wanted to change this factor. 

The solution: To resolve this problem, we have removed all the old fiberglass and seal off all the leaking cracks with our expendable foam named Zypfoam. This helps reduces by a lot the risk of air leaking. After, we blew 16 inches of our TruSoft cellulose to achieve R60 of value. 

The problem

Every winter Mrs. Cherbina had problems with ice dams on the roof of her house. The cause of this problem is the lack of insulation in the attic.

The solution

We removed the old insulation which was made from fiberglass, in order to plug any air leaks on the attic floor with our expanded foam, added baffles in the soffits and then blown a little over 16 '' from our cellulose fiber insulation to achieve an R-60 value.

Problem

Mr. John noticed that some of the upstairs bedrooms were colder than the other rooms. So while our specialist was checking up his place, he had noticed mold problems rot, lack of ventilation, several air leaks on the floor and poor insulation.

Solution

We have removed the fiberglass insulation to seal all air leaks on the attic floor, added ventilation mats in the soffits, insulated the attic access hatch and then blew 17 inches of cellulose.

Facing a humid and moldy attic, the homeowner of a house in Pointe-Calumet contacted us, seeking some help with regards to attic insulation. After careful inspection, our specialist noticed several air leaks still existing within the attic, that weakened the existing insulation's performance, increased moisture levels, and with time caused the developments of some mold spores on the wood.

To solve the issue once and for all, we started by removing the old insulation in order to identify and seal all the sources of air leaks within the attic. We then used our excellent Mold-X2 to remove all the mold spores and prevent them from reappearing. Finally, we blew in a specific quantity of our Trusoft Cellulose Insulation to reach a thermal value of R60. The transformation was radical and our client was satisfied with the results as well as with our professional service.